Lesson 1 - Hello World!

Introduction to your first LED blinking project.  Leddy and Nicolas take you through the steps of your first lesson on how to make an LED blink using your Arduino board, prototype shield, a resistor and an LED.

Make sure to have Node.JS installed on your computer as well as the Johnny-five library.

Arduino IDE: http://arduino.cc
Node.JS: http://nodejs.org
Johnny-Five: http://johnny-five.io


Lesson 2 - Blink three leds

In this tutorial, Nicolas will show you how to connect 3 LEDs and how to blink them at different intervals.  You will need your Arduino board, prototype shield, three resistors and 3 LEDs.

Arduino IDE: http://arduino.cc
Node.JS: http://nodejs.org
Johnny-Five: http://johnny-five.io


Lesson 3 - the RGB LED

In this tutorial, Nicolas will show you how to connect and blink a RGB LED on your Arduino using JavaScript.  Learn how to blink a RGB (Red, Green, Blue) LED using your Arduino board, prototype shield, three resistors and a single LED.  Did you know that using a RGB LED you can make any color you want by mixing three colors together.

Arduino IDE: http://arduino.cc
Node.JS: http://nodejs.org
Johnny-Five: http://johnny-five.io